(Continuation from yesterday)
>sudo apt-get install lirc
Add the following to the last line of /boot/config.txt
>ls -l /dev/lirc0
Check the device file
>sudo /etc/init.d/lirc stop
>mode2 -d /dev/lirc0
Press and pointing the remote control towards the infrared remote control module and try pressing something, it will be displayed variously.
I made the learning file from here.
>irrecord -n -d /dev/lirc0 lircd.conf
(Operation is omitted)
This is the file that I made.
Here is a hard copy.
The person who Buffalo DVR - W1V2 / 1.0T Person broke, can use this data.
Here is /etc/lirc/hardware.conf after change
You can use this command, if this learning was successfully works.
>irw
So, since irsend does not work well (facts and reports, many), make the following two screens and check the operation.
and
-----
Also, it seems that you can not reset the device somewhere in "reboot".
Since I can not reset the network in my case, I also re-inserted the SD card after turning off the power.
Hardware system has many troubles.
-----
From the PC → SSH → Razpai, the second daughter was surprised to see the TV screen changed.